SAW-SPIRALLY WELDED PIPES

SAW spirally welded steel pipes in the following standards according to usage areas.

-Piling pipes, ASTMA -252

-Gas and petroleum pipelines, API 5L
-Water pipelines, AWWA C-200, BS 534, DIN 2460, DIN 1626, TS 1997, UNI 6363
-General purpose pipes, BS 3601, DIN1626
-Pipes specials and fittings, AWWA C-208, BS 534

PRODUCTION RANGE

Outside Diameter (ø) : From 8" (219.1 mm) upto 120" (3048 mm)
Wall Thickness : From 0.157" (4mm) upto 1" (25.4 mm)

Below detailed outside coating and inside lining can be applied to the pipes in order to eliminate corrosive medium effects.

Outside Coating
Epoxy Coating according to AWWA C-210
Bitumen Coating according to DIN 30673, BS 534
Coal-Tar Enamel Coating according to AWWA C-203
3 Layer Polyethylene Coating according to DIN 30670
3 Layer Polypropylene Coating according to DIN 30678

Inside Lining
Epoxy Lining according to AWWA C-210
Bitumen Lining according to DIN 30673, BS 534
Coal-Tar Enamel Lining according to AWWA C-203
Cement Mortar Lining according to AWWA C-205, BS 534

COMPLETE PROJECT MANAGEMENT

In order to assure a smooth and on-time delivery, the "project" should be managed with utmost care and all external or unpredictable factors should be taken into consideration in advance.

Any sophisticated supply project essencially includes (but not limited to) "negotiations", "time scheduling", "quality assurance", "delivery"…

However, as for a steel pipe supply project, some administrative and operational steps comes to the forefront, which naturally affects the project, such as specifying the most appropriate production and shipping plan, warehousing (if needed), organizing the inspection of the production and loading, coordinating the whole transportation process including inland hauling and handling customs clerance procedures, and tracking the transportation as well.

Nevertheless, ODELYA\'s responsibilities for any project never ends at a definite point, regardless of the delivery or payment terms. We carefully arrange and manage each step of a project, from negotiations to the delivery to the "ultimate" destination place.

QUALITY ASSURANCE

To avoid "no-return" damages to the supply project, the risks should be estimated so carefully and characterized in detail.

Thus, importance of such quality-based approach make a comprehensive quality management compulsary, not only for the production but also for the loading and shipment as well. Specifically determining the most appropriate production plan, inspiring our manufacturer partners to innovation and common senses for caring about the quality…

Appointing (independent) "third party inspection" (TPI) organizations and coordinating the inspection plan of the production and loading steps…

These all assure the premium quality of our strategical project management.

INSPECTION TEST PLAN & QUALITY PLAN

Before starting the production, reaching to an multiletral agreement is required for a smooth production and loading. Therefore, each single details of the production and testing phases, from from raw material inlet point to the loading to the transportation vehicles is negotiated by the parties. In no way, the production starts unless the all parties are fully satisfied with the stipulated inspection test plan. In the center of these negotiations, thanks to our experience in various projects and technical knowledge in the area of steel pipe technologies, we are so ready to puzzle over the whole plan and offer the most proper solutions.

THIRD PARTY INSPECTION (TPI)

We appoint worldwide-known independant inspection companies (Third Party Inspection -TPI) companies to inspect the quality of material, production and loading steps in case of any undesirable incidents relating any step of production and shipment.