CONSOLE:Serial port 9600/N/1. Command-line management interface.

MGT: network port. Connected to a computer network port, or WEB management interface.

PWR:Power light. When power-on will light.

SYS: System light. Until the system starts,the bright will light and blink with 1 second intervals.

RST:Reset button. To prevent accidental contact, key is setted in the hole; Long press 5 seconds to restore the system to factory settings.

6 units (GE0 – GE5)1000M electrical interface and 2 SFP (GE6-GE7) interface: each port can be configured as input port or output port

These are ventilation holes

Power supply and switch

Overview:

With the development of network security technology and enterprise security continue to receive attention, based on the safety equipment of network bypass deployment and network traffic analysis equipment gradually increased, the simultaneous deployment of two or more bypass monitoring equipment is not only to increase core switches performance overhead, but can not meet a variety of safety equipment flexible deployment needs. NT-CFTAP-8G Gigabit Ethernet traffic replicator /aggregator monitoring port can be a full line of traffic data replication to multiple monitoring port, and can also support multi-port traffic aggregation capabilities and Hash traffic distribution function, flexibly meet your network security and traffic analysis equipment deployment requirements.

Features:

1. Traffic replication and aggregation

2. Traffic replication engine maximum capability to 8GB

3. Support 6 gigabit electrical interface and 2 * SFP interface to switch input or output mode

4. Support Ethernet independent encapsulation(802.1Q /Q-IN-Q/GRE/PPTP and so on)

5. Support multiple distribution mode( MAC and IP, etc.)

6. Support output interface open the traffic loop-back function

7. Support the CONSOLE, IP/WEB /SNMP, etc management

8. Support the port grouping to save investment

Parameter: