Portable Electricity Saving Box High-efficiency Electricity Saving Box

Feature
1. Saving 30%-50% Of Electrical Consumption
2. Stabilizes The Voltage Supply
3. Improves Efficiency Of Appliances
4. Prevents Electrical Overheating
5. Prolongs The Life Of Electrical Devices
6. Products with convex wave resistance, protection of electrical appliances.
7. Indoor plug and play, had no effect on electrical circuit.
Both men and women, old and young can operate.
8. Installation in 24 hours, can control the current and achieve energy saving effect.
9. Just plug the saver into the wall socket closest to the meter,
one signal phase household require one Power Saver.
10.Suiltable for air conditioner,heating device, washing machine,TV,Refriderator,
lamp and other home appliances.
11.Applicable for family, bar, hotel, Internet cafes, company, shop, small factory.etc.

Specification
Rate voltage: 110~250V, 50HZ-60HZ
Working temperature: -15 degree to 60 degree
Model:Single phase model
Load Power: one power saver for every 18kW
Plug: EU or America

Howdoes it work?
The Power Saver use a state of the electrical technology to actively monitor and improve
the power factor of your household or office appliances.

In addition, the intelligent technology optimizes the voltage and current
demands thus reducing the active power/ KwH demands and achieves up to 35%
savings on your electricity bill. It reduces waveform distortions.

It also acts as a voltage stabilizer by storing emery for up to 10 seconds
and therefore suppliers the load with constant voltage during momentary power surges.
As a result, this power saver prolongs lifespan of the electrical appliances

Super intelligent digital energy saving equipment
It uses a state of the art electrical technology to actively monitor and improve the power
factor of your household / office appliances

The technology optimizes the voltage and current demands to reduce the active
power demands and achieves unto 35% savings on your electricity bill

Warm Note
Please make sure that it is installed as close as possible to the point of entry of your electricity
supply in order to detect all loads before the meter and adjust the power factor accordingly

Picture