slate wall tile adhesive Z5 types of tile adhesive

Introduction:

1,this product is mainly used for cement-based wall and ceramic tile adhesion. Improve the flexibility and deformability of adhesive mortar

2,effectively reduce ceramic tile falls off and empty drum which caused by cement shrinking

3,enhance the adhesive performance of ceramic tile adhesive mortar after water resistant

4,this model applies ceramic tile adhesive mortar.

5: We are recognized as one of the most preeminent Tile Adhesive manufacturers in China. The tile adhesive is mainly comprised of cement that makes it suitable for the fixing of tiles on the external floor and internal walls. These are also well suited for fixing most of the natural stones.

Feature:

1 This product is polymer modified cement tile adhesive, and the performance is better than general cement mortar.
2 Sliding-resistance, dispense with soaking bricks,thin construction layers ,high stickiness,no hollowness,environment friendly,water-fast well.

Application :

A: Waterproof, thin-bed cement-based adhesive for the fixing of ceramic floor, wall tiles and mosaics.

B: It has been specially formulated for use over sand/cement render, is non toxic, easy to apply and no wetting of tiles is required when fixing.It is considerably lighter in comparison with conventional sand/cement mortar and the final weight of the finished of the finished installation is proportionately reduced.just add water and stir mix

C: apply to wall or floor by trowel then fix tile on itable to use on external wall non slip type with long open time for easy adjustment.

D: High bond strength tile adhesive for ceramic tiles, glazed tiles, marble and granite, ideal for tile-on-tile application, for bathrooms, swimming pools.

Surface preparation

1.All the surface should be strong/ dry/ clean, no shake/ oil stain/ wax stain/ concrete curing agent and other loose things.

2.If the surface is covered with paint, it should be hacked and at least exposed 80%.

3.New concrete surface should be cured for 28 days at least. Then pave tile.

4.New plaster base should be cured for 7 days at least. Then pave tile.

5. You can use industrial detergent or degreasing dirt agent to clean the old concrete or plaster surface. Then use high pressure tap to clean up. It can be paved tile after airing 24h.

6. Clean the residue of concrete surface, especially the residual mold release of the slant concrete surface.

7. Before construction, the surface need to be wetted, if the surface is water absorption strong or in high temperature/dry environment.

Technical performance:

Picture:

Buisness Card: