2 Million Gypsum Board Machine Using Coal/Gas As Fuel

Application:

Instruction of EPS Sandwich Panel Machine, EPS Sandwich Panel Making Machine,EPS Sandwich Panel Manufacturing Line:

This is designed to produce fabricated panels for factories, warehouses and house. The line applies E. P. S, Glass & Mineral Wool, Polyurethane and cuts to required length. It is the best material for wall and roof of electronic, medicine, precise machinery and general factories and warehouses.

The is to produce panels for constructing factories, warehouses and houses. After forming 0. 4 ~ 0. 5 mm pre-painted steel sheets, the line attaches them to EPS (Expanded Polystyrene) and cuts into required size. Roof and wall panels can be produced by the same machine.

Feature of EPS Panel Line
1)We holds 2 patents and 2 utilities for EPS Panel Line
2)Thickness of products, 50 mm, 75 mm, 100 mm, etc, can be easily adjusted.
3)Prompt Post Management with the standardization of all parts
4)By data input, it is easy to choose the length and quantity of products
5)Line speed can be regulated at will

Features of EPS Panels

1)Energy saving
You can save air-conditioning and heating expenses remarkably, thanks to its excellent insulation effect as mush as 4. 2 times of cement brick.

2)Perfectly insulated and waterproof
Using the high-density EPS, it is moisture and noise free.

3)Semi-permanence and easy installation
Using galvanized steel sheets treated with fluorine and silicone on the surface, it is unchangeable and semi-permanent. Due to the standardized products, you can save the cost for construction by hiring the least number of workers and minimizing the period of construction.

4)Excellent lightness and firmness
It is light but firm, so even a house is simply built, it is strong enough. Coating with different material, you can enjoy various type of panels.

Specifications:

The main composition of EPS Sandwich Panel equipment assembly line

The whole line of EPS sandwich panel machine consists of 8 parts:

1)Core material conveying rack

2)Closing plate rack
Set one closing plate at each side and each can put one reel.

3)Steel plate dischargerack
3.1 Two sets of glue instruments are for different demands of different plate model.
3.2 Equip it with two pressure and closing structure, including power plant and principal machine complex velocity synchronizing mechanism, which makes closing plate at thickness of 50mm,75mm 100mm,150mmand200mm.
3.3 Be equiped with coil of strip cutoff device to decide lower steel plate.
3.4 Edge milling device is equipped for milling remainder inserted when making EPS core plate with pocket.
3.5 One set reinforcing-bar structure which can put reinforcing-bar up or down to press or not.

4)Principal machine
4.1 Nine pairs of rubber roller move ahead with sandwich plate which is tightened.
4.2 Glue evenly and dropping device.
4.3 One set of glue pump component.
4.4 One set of reinforced-bar device.
4.5 One set of shearing device for cutoff upper steel plate.
4.6 One electrical control box with two transducers for solely controlling velocity of principal machine and output of plastic pump.
4.7 Four jack plate shape machine with adjustable holddown depth.
4.8 Four set of groover.
4.9 All kinds of beaders
4.10 Hand rails and stairway attached each

5)Sandwich plate dinking machine
5.1 One electrical control box and one built-in transducer for controlling speed of cutting knife. And one set of built-in automatic cutting device for controlling cutting fixed length and automatic scaling.
5.2 Holddown cylinder and reposition cylinder.
5.3 One pedestal.

6)Color steel plate tamping machine

7)Main conveying rack

8)Vice conveying rack