reverse osmosis water purifier

Good quality reverse osmosis water treatment plant

2000L/H RO water treatment device

1. Design basic:

Source water quality analysis report: Hardness and related data is over proof.

Source water: Deep well water

Output pure water quality can reach direct drinking requirement.

Water temperature:2—45

Feed water pressure:0.3—0.4Mpa

production capacity:: 2m3/hr

Voltage and Frequency: 230V or 400V 3 phase

Recovery rate:90%~95%, Inflow water capacity: 3m3/H

2. Client should supply basic condition:

Plant size: 4m*1m*1.8m, required floor smooth, floor ground should have drain trench.

Site water supply ability bigger 4t/h. Water quality basic steady, pressure steady,feeding water pressure no less than 0.3MPa.

User power supply:4KW

4.Control method:

Whole system use full/semi automatically control model, both model can be exchanged accordingly. Sand Carbon filter & water softener with auto and manual back flush.The RO system automatic flushing at each startup and shutdown. High water level auto stop, low water level auto start.Pump protected without water.

Protected when no power, poor power, larger electrical current, leakage, short circuit

Two pumps, one for backup(when another fault)

5.Process flow:

Source water tank →Feed water pump → mutimedia filter(sands filter) → active carbon filter →water softener→Cartridge filter→RO permeat tank→use point

6.Process introduction:

Sand filter:

Multi-media filter can remove larger particles suspended solids in water, it need backwashing in regular, to remove the intercept suspended solids, the filtering media is mainly quartz sand,manganese sand, used to remove iron,colloid,silt etc, to make effluent water cleaning. Filter need washing according to water volume at regular, each time washing 10-20 minutes.

Activated carbon filter :

Mainly used to remove organic matter ,colloidal silica ,residual chlorine etc, has strong adsorb ability , water purify activated carbon series adopt superior nut shell or coconut shell as raw material, it has better effect to water purify, it not only can remove odor in water, improve water clarity, such as this impurity in water, Chlorine, mercury, chromium, arsenic, lead, cyanide , pesticide etc harmful matter can highly removal rate.

Water softener:

Full automatic control valve+FRP resin tank + exchange resin+PE brine tank
Application:used in front of UF or RO device, with the function of reduce or remove Ca2+,Mg2+ ionic , extend reverse osmosis system happen inorganic salt scaling time, to protect reverse osmosis membrane system. It can reduce the water hardness and prevent RO membrance scale formation.Used in boiler water,chemical industry,hotel,laundry ,domestic water,textile industry and reverse osmosis pretreatment etc scope.

cartridge filter:

Filtering precision is 5 μm, it will be pretreatment unit of UF influent water, with 7pcs 1m fiber filtering core,

RO system:

Remove all the impurities in the water. Remove rate: 99.9%. It remove the following hard water contaminants that may be present in your water: lead, cooper, barium, chromium, mercury, sodium, cadmium, fluoride, nitrite, nitrate, and selenium.