Powerful Diving Flashlight Torch Underwater 100meters Rechargeable UW Photography for Video Housing W106W

LIGHT FEATURES:

♦ 100 Watt high lumens

♦ Up to 2 hours continuous burn time.

♦ Positive ON/OFF switch

♦ Screw-on rear cover

♦ Video glass reflector(no hot spots)

♦ Wide angle refector

♦ Lightweight

SPECIFICATIONS :

100 WSWC LED Chip

♦Total lumens:10000

♦Correlated color temperature:5000K

♦ Rated median life 1 hours ON /15 minutes OFF:1000 Hours

♦ Warm-up time to 90% of rated output:10 seconds

♦ Start-up time to 90% of rated outpu:5 seconds

100 WSWC Discovery Ballast:

♦Input voltage:18V to 26V

♦Shut down time:3 secods

♦Ballast reset time after shutdown:10 seconds

Weight of unit:

♦On land 800 grams loaded with batteries

♦In seawater 750 grams(with battery pack)

Dimensions:

♦Length 300 mm

♦Width 76 mm

Operating depth:

♦Each unit is pressure tested to 330ft(100m)

♦Will withstand pressure at 500ft(150m)

Full details:

1.Model: archon10000 lumen underwater 100meters led diving torch W106W

2.LED: 100WSWC .Max 10000 Lumens.

3.Color temperature: 5000k

4.Max Runtime: 2 hrs.

5.Three output levels. High>Middle>Low

6.Reflector: without reflector, for underwater photographing only

7.Body material: Durable aircraft-grade aluminum

8.Angle of light beam: 120°

9.Operation voltage: 18V to 26V.

10.Lens: 8mm Polycarbonate Board

11.Surface treatment: Premium Type III hard-anodizing.

12.Color: Black

13.Battery: Li-ion batteries pack

14.With battery over-discharging protection, polarity reversing protection

15.Size: 300(length)*76mm (dia. of head).

16.Weight: 1772 grams (w/battery and charger)

17.Operation Instruction: Successive switching ON-OFF within two seconds to cycle through high, Middle, Low

FAQ

1. I do not use these high-end and multi-function flashlights a lot, what should I pay attention to in use?

.Battery

a. Battery type. Please use the specified battery type according to your flashlight user manual,and if you use rechargeable batteries,please use those with protected circuit.

b.Battery replacement to ensure performance of the flashlight and safety,please replace with same brand,same type and same capacity batteries and make sure to insert batteries correctly with the positive end pointing to the light assembly.

c.Please take out batteries before long time storage to avoid battery leakage which may damage the flashlight components and parts.

.Waterproof O-ring and lubricant

a.Right amount of lubricant will be applied on the flashlight o-rings before shipping out in order to ensure smooth operation and extend the lifetime of the o-rings and for better waterproof as well.When there is little or no lubricant on the o-rings and it's difficult to twist between threads,please apply lubricant on the o-rings in time.

b.The o-rings can be worn out due to ling time use,please replace with spare o-rings attached in the package.

.Max Output

When the light is at Max mode,there is heat coming from battery discharge,drive circuit and LED,the flashlight head will be comparatively hot,please be cautious of touching it;To protect the battery,circuit and LED so as to extend the lifetime of the flashlight,we do not recommend that you run the light at max mode continuously for more than ten minutes.

2.I could not turn on the light normally or it flickers,how to deal with this?
a.Check your battery:If the light can not be turned on it flickers,please check and see if the battery is used up and replace with a new one.

b.Clean the contact end and electricity conducting surface:If the light still can not be turned on after replacing a new battery,please check if there is dust on the positive or negative end,or on the electricity conducting surface,if so,please use a clean cloth to clean the surface.

c.If neither of the above solutions works,please contact your dealer and follow the warranty procedure to repair/replace your light.