Cat5e UTP Stranded Communication Cable

Description:

Stranded Cat5e Ethernet cable is best suited for making custom-length cables. More flexible than solid conductor cable, stranded Cat5e is what most commonly used to make Ethernet patch cables. This bulk cable is in an easy-pull box and can be measured and cut to exact distances, then terminated to an RJ45 connector.

1. Structures: PE insulation, Free PVC, PVC or PE Jacket

2. Standards: ISO/IEC 11801

3. Application: Used as work station out the 100 Base-T4: 100VG-Any LAN; 1000Base-T(Gigabit Ethernet); 155Mbps ATM; 622Mbps ATM

4. Inner Conductor:BC/CCA/CCS/CCAG 4Pairs, 24AWG/26AWG/28AWG 100MHZ

5.Conductor Style: Solid/ Stranded

6.Pair Style: Unshield Twisted Pair (UTP)

7.Certificate: UL/ETL/FLUKE/ISO/CE/RoHS

Specification:

1.CE,ROHS,ISO,UL Compliant
2.Fluke tested
3.Jacket: PVC, LOSH,PE
4.Packing: 305M/Pull box, 100M/Roll, 500M/Pallate

CHARACTERISTICS:

1. Inner conductor: Bare Cooper/CCA( copper-cladding aluminum), Solid or Stranded

2. Diameter of Conductor: 23AWG/ 24AWG/ 26AWG/ 27AWG

3.Insulation:PE/ HDPE

4.Jacket: PVC/PE

5.Color: Any color is available

6.Compliance: ETL verified,UL type CM/CMR/ ISO9001-2000, ROHS compliant .LSZH jacket.

Electrical Characteristics

Q & A

Q: What is the maximum length for a Cat5e & Cat6 cable?

A: The maximum length for a Cat5e & cat6 cable run is 100 meters (328 feet). If longer runs are required, the use of active hardware such as a repeater or switch is necessary.

Q: What is the difference between solid and stranded cable?

A: Solid cable is a 4-pair cable. Within each of the 8 individual wires there is a solid piece of wire covered by a PVC jacket. Because of the solid core of these cables they will be more rigid than stranded cable, but can carry a stronger signal than stranded wire. Solid cable also has the ability to be punched down in to jacks, patch panels, and 66 blocks.

Stranded cable is a 4-pair cable as well. Within each of the 8 individual wires there are multiple tiny stands of smaller gauge wire that are held together by a PVC jacket. Because this cable is made with smaller strands of cable it is more flexible than solid core wire. Stranded Cat5e is typically use for short patch cables. Stranded wire cannot be punched down.

Q: What is shielded cable?

A: Shielded cable is used for increased protection from interference and crosstalk. It is typically used in electrical noisy environments. Common sources of interference are radio towers, high-powered electrical conduit, fluorescent lighting, or any other device emitting electro-magnetic or radio frequency signals.

Q: What is SSTP Cat6a cable?

Cat6a network cables enable 10-Gigabit data transmission over a 4-connector twisted-pair copper cable, allowing connection distances of up to 100 meters. Current Cat6 cabling systems may only support 10-Gigabit Ethernet over limited distances. The Cat6a draft extends the Cat6 electrical specifications from 250 MHz to 500 MHz. It also proposes a new measurement for Power-Sum Alien Crosstalk to 500 MHz. Alien Crosstalk is a coupled signal in a disturbed pair arising from a signal in a neighboring cable.

Q: What is SSTP Cat7 cable?

Cat 7, is a cable standard for Ethernet and other interconnect technologies and are still backward compatible with previous categories of networking (Cat 5, Cat 5e, Cat 6).

These cables are designed to function at 10 Gigabit, over 100m of copper cabling.

Cat-7 cabling supports frequencies of up to 600 Mhz and speeds of up to 10,000 Mbit/s. This is a big improvement on previous network cabling speeds (CAT 3: 10 Mhz, CAT 5: 100Mhz, CAT 6: 250 Mhz). Cat 7a cables can perform up to frequencies of 1000 Mhz and 40 Gbit/s.

CAT7 cables feature even more strict specifications for crosstalk and system noise then CAT 6. This is achieved through shielding on the individual wire pairs and the cable as a whole. Category 7 is recognized for all the country organizations members of ISO.

TIA/EIA 568A/B Crossed Wiring: