All

4-port Gigabit PoE Switch 60W ,48V,IEEE802.3at/af

Location:
Shenzhen, China ( Mainland)
Status:
New
Sample Availibility:
yes
Payment Terms:
Cash, Bank Transfer, Letter of Credit, T/T, L/C
Categories:
Home > Electronics & Electrical > Switches

Product Description

Overview

Manged PoE switch ,supports uplink by optical fiber;

Max transmitting distance:100m;

Plug-and-play design, easy installation and configuration;

Work with wireless APs, IP cameras, IP phones, PDAs and other POE supported devices;

Energy-saving green design, support auto-switch to standby mode and auto-detect cable length;


Characteristics

Supports 4* 802.3af-compliant PDs(power/port: 15.4W) or 2*802.3at-compliant PDs(power/port:30W);

Auto detect IEEE802.3at/af PDs;

SAFC function, only power to IEEE 802.3af/at PDs, won’t damage other private standard POE devices or devices without POE function;

Port power supply prioritization, guarantee the continuous power supply for key nodes;

Flexible network expansion without power line. Wireless APs, IP cameras or other end devices can be fixed on the wall or ceiling;

Built-in PSE power supply module, plug-and play design, easy to install;

High security performance defending against power surge;

Short-circuit protection, can auto cut off power when there is high-current or other power failurs, efficiently defend against device damage or network failures caused by line fault or wrong installation;

Will standby and save power when a port is disconnected , or provide lower power when network cable is less than 10m;

Simple WEB management.

Product Specifications

POE standards

IEEE802.3af/at (max 30w/port)

Total Power

65W

POE Pin-out

1/2(+),3/6(-);Customized 4/5(+),7/8(-)

Switching Capacity

≥16Gbps

Forwarding Mode

Full wire-speed storage and forwarding

Forwarding Rate

10/100/1000M

Operation Temperature

0~50°C

Storage Temperature

—40~70°C

Operation Humidity

10%~90%(non-condensing)

Storage Humidity

5%~90%(non-condensing)

Dimensions

280*180*44mm

Input Power Supply

AC:100-265V ~ 50-60Hz

LED Indicator

Power,Link/Act,POE Status

Energy Saving

Energy Efficient Ethernet

Service Characteristics

Standards and Protocols

IEEE 802.3af,Power Over Ethernet

IEEE 802.3at,Power Over Ethernet Plus

IEEE 802.3u,100BASE-TX

IEEE 802.3ab,1000 BASE-T

IEEE 802.3z,1000 BASE-X

IEEE 802.3ad,Static or Dynamic Link Aggregation

IEEE 802.3x,Full-Duplex Flow Control

IEEE 802.3az,EEE(Energy Efficient Ethernet)

IEEE 802.1q,VLAN

IEEE 802.1p,QoS/CoS

IEEE 802.1d,STP(Spanning Tree Protocol)

IEEE 802.1w,RSTP(Rapid Spanning Tree Protocol)

MAC Address Table

8K for 4/8 POE,16K for 16/24 POE

auto-update, two-way learning

VLAN

4096 VLANs

Port-based VLANs

VLANs based on IEEE 802.1q

Spanning Tree

Spanning Tree Protocol

Rapid Spanning Tree Protocol(RSTP)

Link Aggregation

2 aggregation groups,max 4 ports per group(for4/8 PoE)

8 aggregation groups, max 4 ports per group(for16/24 PoE)

Port Mirroring

Bi-direction port mirroring

Loop Guard

Loop Guard, real-time detect,quick alarm,precise localization, smart blocking and auto-recovery

Port Isolation

Isolate downlink ports without influence the communication between downlink and uplink ports

Port Flow Control

Back-pressure traffic control under Half-Duplex mode

IEEE 802.3x traffic control under Full-Duplex mode

Port Rate Restriction

Port-based ingress or egress rate limiting

Jumbo Frame

Max 9216 Byte

Multicast Control

IGMP Snooping

Storm Suppression

Suppression of broadcast storm based on forwarding rate

Security

Port-base MAC address binding

Security restriction on port-based MAC address quantity

QOS

SP(Strict Priorty)

WFQ (Weighted Fair Queuing)

WRR (Weighted Round Robin)

802.1p(Port Queuing Priority)

Differentiated Service Code Point(DSCP Priority)

Physic Medium

10/100Base-TX:UTP category 3/4/5 cables( Maximum 100m)

1000Base-T:UTP Category 5 cable( Maximum 100m)

1000Base-SX:fiber with 850nm wavelength,max transmission distance of 550m

1000Base-LX:fiber with 1310/ 1550nm wavelength,max transmission distance of 80km

Networking

Auto-MDIX function, automatically identify straight forward cable and cross-over cable

Negotiation Pattern

Port auto-negotiation function( automatically negotiate transmission rate and Duplex modes)

PHY Detection

Detect the connectivity of network cables

Maintenance

Upload or download configuration data

Upload upgrade patch

WEB-based reset to factory defaults

Port short-circuit reset to factory defaults

Management

WEB-based management



This member's information has NOT been authenticated or verified by importexportleads.net or any third party. Only Gold Members have completed an authentication and verification procedure conducted by third-party credit agencies.

For more information on importexportleads Gold Membership, Click here

Contact Information

Company:
 Shenzhen TG-NET Botone Technology Co., Ltd.
Phone Number:
  86-755-33917730
Fax Number:
 86-755-33917727
 
Shenzhen TG-NET Botone Technology Co., Ltd.
 Guangdong , China FREE
 

Resources