MODEL

NES-15-5

OUTPUT

DC VOLTAGE

5V

RATED CURRENT

3A

CURRENT RANGE

0~3A

RATED POWER

15W

RIPPLE & NOISE (max.) Note.2

150MVP-P

VOLTAGEADJ.RANGE

4.75~5.5V

VOLTAGE TOLERANCE Note.3

±2.0%

LINEREGULATION Note4

±1.5%

LOADREGULATION Note5

±1.5%

SETUP.RISEHOLD.TIME

1000ms, 30ms/230VAC 1000ms, 30ms/115VAC at full load

HOLD TIME(TYP.)

100ms/230VAC 20ms/115VAC at full load

INPUT

VOLTAGE RANGE

85~264VAC 120~370VDC

FREQUENCYRANGE

47~63HZ

POWER FACTOR (Typ.)

0.96/230VAC 0.96/100VAC at full load

EFFICIENCY (Typ.)

79%

AC CURRENT (Typ.)

0.35A/115VAC 0.25A/230VAC

INRUSH CURRENT (Typ.)

COLD START 45A

LEAKAGECURRENT

<2mA/240VAC

PROTECTION

OVERLOAD

Above 105% rated output power

Protection type : Constant current limiting, recovers automatically after fault condition is removed

OVER VOLTAGE

5.75~6.75V

Protection typeShut off

OVER TEMPERATURE

U1 TJ 140 typically (U1) detect on main control IC

Protection type : Shut down o/p voltage, recovers automatically after temperature goes down

ENVIRONMENT

WORKING TEMP

-20~+60°C (refer to output load derating curve)

WORKINGHUMIDITY

20~90% RH non-condensing

STORAGE TEMP HUMIDITY

-40~+85 10~95%RH

TEMPCOEFFICIENT

±0.03%(0~45)

VIBRATION

10~500HZ,2G10min/1cycle,60 min each alongX,Y,Zaxes

SAFETY&EMC

SAFETY STANDARDS

UL60950-1, CB(IEC60950-1) approved

WITHSTAND VOLTAGE

1/P-0/P:3KVAC 1/P-FG:1.5KVAC 0/P-FG:0.5KVAC

ISOLATIONRESISTANCE

1/P-0/P,1/P-FG,0/P-FG:100M Ohms/500VDC

EMI CONDUCTICN&

RADIATION

Compliance to EN55022(CISPR22)classB

HARMONICCURRENT

Compliance to EN61000-3-2,-3

EMS IMMUNITY

Compliance to EN61000-4-2,3,4,5,6,8,11 ENV50204,EN550204,EN61000-6-1, Light industry level criteriaA

QTHERS

MTBF

563.5Khrs min MIL-HDBK-217F(25)

DIMENSION

79*51*28mm(L*W*H)

PACKING

0.18Kg 60pcs / 11.8Kg / 0.46CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4.Line regulation is measured from low line at rated lioad

5. Load regulation is measured from 0% to 100% rated load.

6.The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.