SDI Video Input
Signal Standard SMPTE 259M270 Mbps,525/625 SD component
Impedance 75 ohm
Return Loss >18dB to 360MHz
Connector BNC (IEC169-8)
Equalization Automatic equalizing to 30dB@270 Mbps
SDI Video Output
Signal Standard SMPTE 259M-C270 Mbps,525/625 SD component
Connector BNC (IEC169-8)
Impedance 75 ohm
Return Loss >18dB to 270MHz
Signal Level 800 mV ± 10%
DC Offset 0 V ± 0.5 V
Rise and Fall Time 400 to 1500ps20% to 80% of amplitude
Overshoot <10% of amplitude
Jitter <0.2 UI740pspeak,typical<500ps
Analog Composite Video Output
Signal Standare NTSC, PAL or PAL-M
Level 1Vp-p +/-3dB
Impedance 75 ohm
Return Loss >40 dB to 5 MHz
DC Offset 0V±0.05 V
Frequency Response ±0.2 dB to 5 MHz
Differential Gain <1%
Differential Phase <1.5°
Group Delay +/-10ns to 5 MHZ
Unbalanced AES Outputsapplicable to SMX6810N(S)-U2
Connector BNCIEC 169-8
Output Level 1.0 V +/-10% (peak to peak)
DC offset 0.0V±50.0mV
Rise and Fall Time 30 to 44 ns (10% to 90% of amplitude)
Impedance 75 ohm
Return Loss >25 dB, 0.1 to 6.0 MHz
Analog Audio Input
Connector 3-pin
Analog Input Level 28-16dBu
Frequency Response +/-0.05dB (20-20KHz)
THD+N -95dB, 20-20KHz@-3dBFS
Crosstalk -95dB(20-20KHz)

Balanced AES Output (applicable to SMX6810N(S)-B2 )
Connector 3-pin (male)
Output Level 2.0 to 7.0 V (peak to peak)
Jitter +/-20 ns
Rise and Fall Time 5 to 30 ns (10% to 90%)
Impedance 110 ohm +/- 20% (0.1 to 6 MHz)
CMR Ratio >30 dB below output signal (0 to 6 MHz)
DARS Input
Connetor 3-pin (male)
Sensitivity < 200mv
Impedance 110 ohm +/- 20% (0.1 to 6 MHz)
Maximum Input Level 10Vpeak to peak
CMR Ratio >30 dB below output signal (0 to 6 MHz)
Unbalanced DARS Input
Connector BNCIEC 169-8
Sensitivity < 200mv
Impedance 75 ohm
Return Loss >35 dB, 0.1 to 6.0 MHz
DATA IN
Input Impedance 75ohm/high impedance (jumper selectable)
Input Sensitivity 500mV pk to pk(minimum)
Input Cable Length 100 meter
Return Loss <-20dB
Power Consumption
Power 3.5W
Positive Rail 550 mA
Negative Rail 10 mA