poe

Features and Functions
POE PROCET PT-PSE801 is an eight ports concentrated network remote power supply implement. It is suitable for indoor, can be installed on standard rack, can work regularly between 100VAC ~ 280VAC input voltage. This power supply use super type 5 cable to connect with network terminal equipment, is suitable for 10/100 M network environment.

Discrete noise voltage

3.4KHz~150KHz≤5mv
150KHz~200KHz≤3mv
200KHz~500KHz≤2mv
0.5MHz~30MHz≤1mv

Ethernet ports light instructions
Red light POWER on:Show power working normally
Green light ACTIVE on: show equipment supply power normally

Green light in network port is on and then off after several seconds show overload protection or short circuit.

Red light shining slightly in use shows feed part of the network port is off-loads, can judge there is a glitch of the power supply or far-end equipment.

Installation and Commissioning

1. Insert the input power line into 100--220VAC introducing input socket.

2. Connected output signal cord respectively
3. Connect communicating & introducing line, signal wire, output lines tightly to avoid bad contacts and loose.

Note
Item 1: The installation site must be away from heat source and electromagnetism interference source, non-corrosive gas and metal dust.
Item 2:Mustn’t block the cooling hole of the equipment.

Item 3: Installation must be stable fixed placing, not a violent shock.
Item 4: Note whether the AC input voltage is during the range of 100VAC ~ 280VAC.
Item 5: Prevent to crash and conflict with other equipment during the installation, so as not to cause local damage of the machine surface.

Boot Test

1.Using resistance gears of millimeter to detect Ac input, short circuit phenomena did not exit; after loading, green light in output interface is on shows output normally. If it is off after several seconds shows short circuit and limited flow phenomena did exit.

2. After electric communication, the working light in front board is on

Daily Maintenance

Long-distance power supply POE PROCET PT-PSE801 can work uninterruptedly,to guarantee the reliability of the power supply, must prepare daily maintenance work, make the power system in the best working state.
1. Clean power source regularly to prevent dirt retention phenomenon

2. Check whether the connecting line of input and output is loose or contact undesirable, if damaged, please change in time.

Storage
When storing, must be kept in dry warehouse, not exposure to sun and rain.
Storage temperature:-5°C~+55°C (low temperature storage recovery time is at least 4 hours),
Relative humidity:5% ~90%RH