network equipment

Equipment description

Features and Functions

poe PROCET PT- PSE108G-Tis a single-port split network remote power supply device. It is suitable for indoor, meet IEEE802.3at standard ,can work normally between 100VAC~280VAC input voltage. This power supply use category super type 5 cable to connect to other network termination equipments, is suitable for 10/100/1000M network environment,effect distance of power supply is 100M.

poe ROCET PT- PSE108G-T POE has the following excellent performance:

1.The power circuit has the function of Input over or under voltage, output over voltage, output over-current short-circuit protection for each circuit.

2.System reliability:MTBF>100k hours.

3.Conducted interference(CE)and Radiated interference(RE),comply with EN55022, CLASS B standard.

4.Lightning protection: Both positive and negative port of AC input can take 5KB, 8/20uS pulse current for 5 times, with interval of one minute. Power supply lightning protection circuit has the failure alarm function and safety protection devices like insurance tube etc.

Operating Environment

1.Temperature: -15°C~+55°C

2.Relative humidity: 5%~90%RH

3.Places that are ventilate and cool, clean, no conductive dust, no corrosive gases.

4.Places without explosion hazard.

Technical characteristics and parameters

1.Input voltage: 100VAC~280VAC,47Hz~63Hz.

2.Maximum power output: 36W.

3.Output voltage regulation accuracy: -48VDC±2%.

4.Load regulation: -48VDC±1%.

5.Operating temperature range: -15°C~+55°C.

6.DC output voltage of broadband noise: 3.4kHz~150kHz≤50mv

Dimensions and weight:

Width: 60mm

Length: 160mm

Height: 32mm

Weight: <160g

Remote power supply protection:

Range of output over-voltage protection: -52VDC~-50VDC

Over-current protection(Single circuit): 350Ma~400Ma

Over voltage protection: Input voltage over 290VAC~310VAC

Over voltage recovery point: Input voltage over 285VAC

Under voltage protection: Input voltage under 80VAC~85VAC

Under voltage recovery point: Input voltage under 90VAC

Over-temperature protection: >100°C

Ethernet ports light instructions
Red light POWER on:Show power working normally
Green light ACTIVE on: show equipment supply power normally

Installation and Commissioning
1.Connected output signal line respectively

2.Connect communicating & introducing line, signal wire, output lines tightly to avoid bad contacts and loose.

3. Insert the input power line into 110-220VAC introducing input socket.