Product:

z-wave insert module TZ71

Module:

TZ71

The Embedded Switch Control module is a component of the lighting control system of TKBHOME.

This Control module is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other types can be
added to the system and will also act as repeaters if they support this function of repeating the signal received to
other modules in the system.

As part of a Z-Wave network, the TZ71 will also act as a wireless repeater to insure that commands intended for
another device in the network are received. This is useful when the device would otherwise be out of the radio
range of the wireless controller.

When TZ71 Embedded switch connect with mechanical switch, the connected mechanical switch can still work by
manual control the attached load even if this electronic switch module broken, to provide users with the lighting
needs, avoid the system paralysis and enhance the dependability of the system.

There are no field repairable assemblies on this unit. If service is needed, the unit must be returned where purchased.

Features:

Very small sizeEasy installVery low power consumptionCan control up to z-wave 10 devicesControlled z-wave groups:2The attached load can still be controlled by traditional switch even if the module is broken.

SPEC.

Power: 230 VAC, 50 Hz

Signal (Frequency): 868.42 MHz

Maximum Load – Resistive: 6 amps (1380 watts) maximum, 230 VAC

Range: Up to 30 meters line of sight between the Wireless Controller and /or the closest ZWave Receiver Module.

TZ71 Installation:

+ =

TZ71 Wiring Diagram :

L: Line Voltage Input

L':Switched load output

N:Neutral

K1,K3:Switch attached load control port

K2:Associated devices control port

COM1: K1 Switch loop port

COM2: K2 switch loop port