Dehumidifying Dehumidifier Damp Moisture Absorbing Egg

If the humidity indicator on the sides of the egg is BLUE (dry), the egg is ready for use .

If the humidity indicator on the sides of the egg is PINK (wet), the egg needs to be re-activated.

Warning:

Before placing in the microwave or oven for re-activation, inspect the egg completely for any cracks or damage.

Re-activation:

To re-activate the egg, remover the egg from its base and place the egg in the microwave on the medium heat(600w) for 10 minutes.

Warning:

Egg will be extremely hot after re-activation. Wait at least 10 minutes before handing and replacing the sealing pad .

Caution :

1, Egg is made of multi-porous ceramic material and may break if dropped.

2. Do not open the rubber sealing pad on the bottom of the egg to prevent the moisture-absorbing granules from falling out .

3. Before each re-activation, check the egg for any damage or cracks. If the egg is damaged, discard immediately . Do not put in the microwave or oven for re-activation.

4. During re-activation, there may be some hissing sounds, this is due to the water vapors, this is completely normal and will not contaminate or damage your microwave or oven..

5. If needed, use a cloth to clean the egg, Do not immerse in water.

6.Do not put the base in the microwave or even.

If you do have a microwave, you can also re-activate the egg using a conventional oven

Remoce the egg from its base .Turn the egg upside down and remove the sealing pad carefully to avoid any of the granules from falling out.Place the egg in a ceramic or other oven safe mugHeat for 30 minutes at 300°F